While minimizing space requirements and sparing that "puffy" look you might expect from a recliner, this zero wall recliner doesn't hold back when it comes to contemporary style. Subtle touches such as sporty jumbo stitching, nailhead trim and a "weather worn" effect on the upholstery give this handsome piece a buttoned-up appeal and fresh feel.
FEATURES
Zero wall design requires minimal space between wall and chair back;Pull tab reclining motion;Corner-blocked frame with metal reinforced seat;Tight back and seat cushions;High-resiliency foam cushions wrapped in thick poly fiber;Nailhead trim with antiqued goldtone finish
SERIES FEATURES
FEATURES
Zero wall design requires minimal space between wall and chair back;Pull tab reclining motion;Corner-blocked frame with metal reinforced seat;Tight back and seat cushions;High-resiliency foam cushions wrapped in thick poly fiber;Nailhead trim with antiqued goldtone finish
SERIES FEATURES
All of our furniture comes with a 1 Year Manufacturers Warranty against manufacturing defects. The warranty covers defects such as major wood cracks, veneer pops, visual wear and tear on upholstery, or malfunctioning of reclining. MM Furniture reserves the right to determine if the issue is warrantable. Most of our wood products have very low defect rates. However, upholstery products, especially reclining products, even the most high end, have much higher defect rates. The cost effective 5 year protection plan is a solution we strongly recommend for all customers whose purchase upholstery products.
Warranty is not covered for any of the following conditions:
- COMMERICAL use on any commercial space.
- WOOD Any natural effect in color variations or graining, natural characteristics such as knots, mineral streaks, or pitch pockets.
- MARBLE Any natural effect in color variations or graining and veining are to be expected and not considered defects.
- METAL Natural aging of metals, rust, or tarnishing due to scratches or abrasions.
- GLASS Small air bubbles, surface waving and lightly pitted areas may occur during manufacturing and are not considered defects.
- LEATHER natural markings, grain variations, and minor indentations.
- Changing colors and texture of fabrics, leathers, marble, or wood finishes over time.
- Damages due to normal wear and tear.
- Improper maintenance, improper use, improper cleaning, improper installation, or use other than intended.
- Damages incurred during assembling or maintenance.
